P5 Primer Adhesion Promoter - 200ml

Descrição

The P5 Primer by Marabu is a liquid adhesion promoter, developed for the pre-treatment of a variety of materials, with the aim of improving the adhesion properties between the material and the paint layer to be applied. It is ideal for preparing difficult surfaces, such as glass, metals, ceramics and plastics, for printing with digital or screen-printing UV inks.

Field of Application

Primer P5 improves the adhesion of UV curable paints on:

• Glass

• Metals

• Ceramics

• Plastics

This primer is essential to ensure adhesion on surfaces that normally present challenges for printing, providing durability and superior quality to the printing process.

Processing Instructions

• Recommended Processing Temperature:
  Between +15°C to +25°C.

• Drying:
  Drying time for thin layers is approximately 30 seconds at room temperature. Recommended waiting time before printing or further processing is approximately 5 minutes.

After application, substrates should be protected from direct sunlight. Processing should take place within 5 hours after application of the primer to ensure maximum adhesion. If the substrates are stored in a dry place protected from light, they can be processed later.

Application Methods

• Manual Application (Cloth):
  Primer P5 can be applied by hand using a lint-free cloth, clean paper towel or clean cotton pad. Apply the primer evenly and thinly in a circular motion without applying excessive pressure.

• Spray Application:
  For finer application, it is recommended to use spray guns with compressed air atomization. Nozzles of 0.5 mm to 0.6 mm and atomization pressure between 4 and 6 bar are ideal. Parameters should be adjusted according to the equipment used to avoid the formation of streaks or stains.

Additional Information

If you have any questions about using Primer P5 , contact Marabu technical support for more information.